![](https://images.caxton.co.za/wp-content/uploads/sites/26/2014/05/s7.jpg)
Paint them in any colour you like using Rust-Oleum 2X spray paint. The ones shown above are spray in gloss apple red (top), satin aqua (middle) and satin espresso (bottom. You will find the full range of glorious 2X colours at your local Builders Warehouse.
YOU WILL NEED:
2 of 16mm SupaWood 400 x 500mm – sides
2 of 16mm SupaWood 300 x 800mm – panels
1 of 16mm SupaWood 280 x 800mm – shelf
of 3.5 x 30mm wood screws
Wood filler
Rust-Oleum 2X in your choice of colour
120- and 240-grit sanding pads
TOOLS:
Drill/Driver plus assorted bits
Countersink bit
Jigsaw and clean-cut blade
Sander
Tape measure and pencil
Steel rule or straightedge
1. Cut out the panels as shown below. The cut outs are 50mm wide and 700mm long.
2. Cut out the sides as shown below. Each section is 50mm wide and the corners are nicely rounded off.
3. On the side and panels are cut, you will place the panels onto the sides and use a pencil to mark where the panels will be placed. This allows you to pre-drill 3mm pilot holes and countersink ready for assembly.
Here’s a close up of the sides showing the pencil marks where the panels and shelf will be mounted.
By doing this you can accurately gauge where to drill the 3mm pilot holes.
4. On the sides, insert the screws so that just the tip is showing on the back side. Using the drawn lines as a guide, place one end of a panel into place and press down.
The screw tips act in the same way as a dowel centre would, by making a mark on the edge of the panels to indicate where you need to drill a 3mm pilot hole.
5. Repeat the above step so that you know where to drill 3mm pilot holes to mount the shelf.
6. Secure the panels to the one side, and the shelf to the sides using 3.5 x 30mm wood screws.
Cover the holes up with wood filler and leave this to dry.
7. With one side attached you can repeat the process to make marks and drill 3mm pilot holes on the other end of the panels.
Secure the remaining side to the panels.
Here you can see how the sides are panels look once joined together.
8. Lastly, attach the shelf in place using 3.5 x 30mm wood screws and fill the holes with wood filler.
Finishing
Sand the entire project with 120-grit sanding pads if there are any uneven edges and then sand with 240-grit sanding pads to smooth and polish the cut edges before painting.
To reduce the amount of spray paint required, I now apply a coat of white acrylic PVA (Plascon Polvin) to my pieces as a base coat. Once dry, this is sanded smooth with 240-grit sandpaper and wiped clean before spraying. This cuts down on the amount of paint absorbed into the SupaWood and means you use far less paint.
Article courtesy of EasyDIY
More DIY:
Top tips for a DIY kitchen revamp